Special Cartoon protective exporting power supply carton,Packing:0.24Kg ; 54pcs/15Kg/1.12CUFT; Dimension:123.5*81.5*23mm (L*W*H)
Shipped in 5 days after payment
MEAN WELL LED DRIVER LCM-40DA 350mA 700mA 1050mA 40W led driver with DALI interface and push dimming function
1.Output current level selectable by DIP S.W. 2.Built-in active PFC function 3.Protections: Short circuit / Over temperature 4.Cooling by free air convection 5.Fully isolated plastic case 6.Class 2 power unit, no FG 7.Built-in 0~10Vdc and PWM signal dimming function 8.No load power consumption <1.2W(Note.7) 9.Power supplies synchronization function up to 10 units 10.3 years warranty
LCM series is a single unit supplies multiple current levels,350mA/500mA/600mA/700mA/900mA/1050mA. The current levels are able to be easily switched by adjusting the built-in switch. LCM switching power supply also provide the dimming function that is controlled by external 0-10VDC or PWM signal or resistance. Moreover, the synchronization design allows the dimming for up to 10 units of LCM led driver to be controlled. Differentiating from general DC output power suppliers, LCM series power supply built-in DALI interface and push dimming function for LCM-25DA/40DA/60DA, multiple-stage C.C. level selectable by DIP switch.
Once you’re found an Mean well LED driver, Kulon Electronics will make your Mean well placing order easy. These LED drivers suitable for indoor LED lighting, office LED lighting and LED decorative lighting. “Total quality assurance and customer satisfaction” are the central goals of our company.
2 ~ 100V
2 ~ 80V
2 ~ 57V
2 ~ 45V
2 ~ 40V
RIPPLE & NOISE (max.)
VOLTAGE ADJ. RANGE
SETUP, RISE TIME
500ms, 80ms / 230VAC at rated power
HOLD UP TIME
16ms/230VAC at rated power
180 ~ 295VAC 254 ~ 417VDC
47 ~ 63Hz
Constant current limiting, recovers automatically after fault condition is removed
110 ~ 130V
Protection type : Shutdown o/p voltage, re-power on to recover
Shut down o/p voltage, re-power on to recover
-30 ~ +60 (Refer to "Derating Curve")
20 ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY
-40 ~ +80 , 10 ~ 95% RH
±0.03%/ (0 ~ 50 )
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
a. Select suitable wattage based on customer’s system requirements and application methods. Must also take excess power and driving method into consideration.
For selection key points when using MW power supply to “directly” drive LED lamp refer to questions (2) and (3).
For selection key points when using MW power supply in combination with LED driver IC to achieve high precision current control refer to questions (2) and (3).
b. Based on LED power supply’s operating environment select suitable IP level and mechanical type (metal enclosure, plastic enclosure, and open frame PCB) for that environment.
c. Is PFC function required or not? Single stage PFC is only suitable for LED load. Dual stage PFC is suitable for general applications.
d. If LED system is based on direct drive, units with adjustable voltage and current should be considered for flexibility in changing voltage/current levels. Dimming function may also come in handy when LED brightness control is preferred.